Body Fat Calculator

Estimate your body fat percentage from circumference measurements using the U.S. Navy circumference method. Body fat percentage describes body composition more directly than BMI, which only uses height and weight.

Body fat (US Navy)

16.9%

Who should use it: Adults tracking fitness progress who want a convenient body composition estimate that goes beyond BMI, without clinical equipment.

How to use this calculator

  1. 1Choose metric or imperial units and enter your age, sex, height, and weight.
  2. 2Measure your neck just below the larynx (Adam's apple) and enter it in centimeters.
  3. 3Measure your waist and enter it in centimeters — at the navel for men, at the narrowest point for women.
  4. 4If you selected female, also enter your hip measurement at its widest point.
  5. 5Read your estimated body fat percentage.

Understanding the inputs

SexSelects the correct Navy equation. The female equation includes the hip measurement; the male equation does not.
HeightUsed in centimeters together with the circumference measurements. Imperial entries are converted first.
NeckMeasured just below the larynx, keeping the tape horizontal and relaxed. A thicker neck lowers the estimated body fat.
WaistMeasured at the navel for men and at the natural waist (narrowest point) for women, after a normal exhale.
HipRequired for women only, measured at the widest point around the buttocks.

How the calculation works

The U.S. Navy method estimates body fat percentage from circumference measurements using established logarithmic equations developed from Navy personnel data. For men it uses height, waist, and neck; for women it adds the hip measurement. The equations convert the difference between waist and neck (plus hip for women) relative to height into an estimated body fat percentage. It is a convenient field estimate and is less precise than clinical methods such as DEXA, hydrostatic weighing, or air displacement plethysmography.

Men: %BF = 495 / (1.0324 − 0.19077·log10(waist − neck) + 0.15456·log10(height)) − 450; Women: %BF = 495 / (1.29579 − 0.35004·log10(waist + hip − neck) + 0.221·log10(height)) − 450

Worked example

Scenario: A 180 cm man with an 85 cm waist and a 38 cm neck.

Result: Estimated body fat ≈ 18%, which falls in the typical adult range. The exact figure depends on precise, consistent measurements.

How to interpret your result

Your result is an estimated body fat percentage, which describes what fraction of your body weight is fat versus lean tissue (muscle, bone, water, organs). General adult reference ranges are roughly 10–20% for men and 18–28% for women, with fitness and essential-fat thresholds varying by source. A single number is most useful for tracking change over time under consistent measurement conditions, rather than as an absolute judgment of health. Body fat percentage alone does not indicate fitness, metabolic health, or where fat is stored.

Factors that can affect the result

  • Measurement consistency: small changes in where you place the tape shift the result, so measure the same sites each time.
  • Time of day: waist and hip measurements change with meals, hydration, and bloating, so measure at a consistent time.
  • Body composition and build: the Navy equations were developed on a specific population and can be less accurate for very muscular or very lean people.
  • Age and sex: body fat distribution changes with age, and the male and female equations differ.
  • Hydration: water retention affects circumference measurements and therefore the estimate.

Limitations and assumptions

  • The Navy method is an estimate and can vary by several percentage points from clinical measurements such as DEXA.
  • It does not directly measure fat — it infers it from circumferences, so it cannot distinguish subcutaneous from visceral fat.
  • The equations were derived from military populations and may be less accurate for older adults, athletes, and people with atypical builds.
  • Results can vary by measurement method, body composition, age, sex, and other factors — this is not a definitive medical assessment.
  • It should not be used to diagnose obesity, metabolic health, or any medical condition.

Frequently asked questions

Related calculators

Related guides

Methodology

Body fat percentage is estimated with the U.S. Navy circumference equations, which use height, waist, neck, and (for women) hip measurements. Imperial entries are converted to centimeters before the equations are applied. The result is a field estimate, not a clinical measurement.

Sources and references

Last reviewed: August 2026. Read our editorial policy.

Disclaimer: This calculator provides general estimates and is not a diagnosis or a substitute for professional medical advice. Results depend on the accuracy of the information you enter and on individual factors this tool cannot measure. Always consult a qualified healthcare provider regarding your health, diet, exercise, or any medical condition. Read the full disclaimer.